How did the hardware stamping parts come from?
The source of metal stamping parts has advantages in other aspects compared to other processing methods. Mainly as follows. 1. Metal stamping processing range of large size, various shapes of parts can be stamped out, coupled with the cold deformation hardening effect of metal stamping, the strength and rigidity of stamping are higher. 2. Metal stamping usually has no chip waste, which consumes little material, and does not need to heat the equipment, which will not cause waste. It is an energy-saving processing method, and the cost of metal stamping parts is still very low. 3. The metal stamping parts processing has high production efficiency, convenient operation and easy mechanization and automation. This is because the stamping relies on die and stamping equipment to complete the processing. Usually, the number of strokes of the press is up to several tens of times per minute, and the high-speed pressure can be hundreds of times or even thousands of times per minute, and each press stroke is performed. May get a punch. Concerned about surprises Label: How did the hardware stamping accessories come from? Previous: Simple maintenance and maintenance of electric screwdrivers Next: Hardware interpretation: the bearing clearance causes the grease to change color JXHS series Junction Box advanced technology during production, stresses the details during design, implements design standard during processing, and has high consistence of product quality. It has various features such as strong damp proof, anti-corrosion and anti-electromagnetic capacities and high adjustment accuracy, and is suitable for various adverse environments. Its main advantages include: The Junction Box,6-Wire Surge Proof Junction Box,8-Wire Surge Proof Junction Box,Surge Proof Junction Box SHANDONG JINZHONG SCIENCE & TECHNOLOGY GROUP COMPANY LIMITED , https://www.chinagoldbell.com
The product uses own mold to make technologic design, the housing uses aluminum and silicon alloy and upper protrusion and lower sinking structure is used so as to ensure good sealing performance; protective grade reaches IP 68.
Main parts are imported, wiring bar is welded with precise anti-surge electronic components, which can prevent Load Cell damage caused by lightning and power grid surge voltage.
Whole device uses stainless steel grounding bolts to ensure reliable grounding during operation.
Assembly of junction box uses not-loose screws so as to avoid loss during load cell wring.
Wiring board uses combined screws for assembly, which are convenient for removal.
In order to ensure protective effect, force and diameter of tightening parts have introduction.