Ceiling lamp cleaning and maintenance precautions
Since ceiling lamps are typically installed in high locations, the lampshade and bulb can be fragile and prone to breaking. When removing the lampshade, it's best to have two people work together for safety. Before starting any cleaning or maintenance, always turn off the power supply to avoid electrical hazards. Also, avoid using a wet cloth to clean the lamp holder, as this could lead to a risk of electric shock. The method for cleaning a ceiling lampshade depends on the material it's made from. For fabric lampshades, start by using a small vacuum cleaner to remove loose dust. Then, apply a mild detergent and gently scrub the surface with a soft cloth. However, if the inside of the lampshade is made of paper, avoid using liquid detergents directly, as they may cause damage. Instead, use a dry cloth to wipe it gently. For frosted glass lampshades, a soft cloth combined with a small amount of toothpaste works well for cleaning. If there are textured areas, wrap a soft cloth around your fingers or a small brush to reach those hard-to-clean spots effectively. When cleaning the lamp holder, begin by removing any visible dust. Then, use a soft cotton cloth to wipe it down. Be careful not to leave any water residue on the metal parts, as this could cause rust or electrical issues over time. Always make sure the area is completely dry before reassembling or turning the power back on. When cleaning the entire ceiling lamp, it's recommended to wear a pair of light cotton socks or gloves to protect both your hands and the lamp’s delicate surfaces. Gently wipe each part without moving internal components. After cleaning, ensure that all parts are reinstalled correctly, and double-check that nothing is missing or misplaced. This helps maintain the lamp’s functionality and appearance for a longer period. Copper nuts made of all kinds of embossed wire (usually lead brass, such as H59, 3604, 3602). Our daily contact with the embedded knurled copper nuts are processed by precision automatic lathes. The reference standard of embedded knurled copper nut comes from GB/T809, but the technical parameters of all kinds of embedded nuts produced by our company exceed the relevant indexes required by the national standard. Brass Nut,insert nut,knurled nut,injection nut,hex nut Shenzhen Lanejoy Technology Co.,LTD , https://www.szlanejoy.com
Knurling copper nut is mainly used for hardware Spring, shaped spring, craft gift spring, battery spring, spring antenna,key ring, phosphorus copper spring CNC automatic lathe turning parts (copper car parts, iron, aluminum car parts), metal stamping parts, electronic parts, iron shaft, single Rachel,Rachel, iron pin, non-standard Screw nut,fittings,fasteners, wire forming (wire card holder, Model aircraft landing gear, S hook, R latch, triangle buckle, D buckle) and other hardware products, belonging to the copper nut series.