【China Aluminum Industry Network】 1. It is important not to heat the welding rod with the torch first and then pick up the welding powder, as the melting point of the welding rod is too low, which can cause it to melt prematurely.

2. A successful first-time weld produces a better result because the aluminum tube has a low melting point. If reheated, the tube may easily deform, leading to poor quality or failure.

3. Always place a wet towel inside to protect the area during welding. The welding space is often very tight, so protecting the refrigerator from heat damage is crucial.

4. Avoid using a long flame; instead, use a small, controlled flame. A strong flame can cause the dispersant aluminum tube to melt easily, affecting the integrity of the weld.

5. After completing the welding, allow the special nylon filament slurry to cool the tube for two to three minutes before connecting it to the cement reservoir. Failing to do so may result in leaks at the solder joint.

6. Make sure to apply flux evenly on the electrode to ensure a strong and reliable solder joint. This step is essential for achieving a high-quality weld.

7. Keep the welding time short, as prolonged heating can cause the aluminum tube walls to thin or even melt, increasing the risk of pressure leaks.

8. Do not use the welding rod to preheat the torch, as the rod's low melting point makes it unsuitable for this purpose.

In addition to these steps, always ensure proper ventilation and wear appropriate protective gear when working with welding equipment. Proper preparation and attention to detail can significantly improve the success rate and durability of your aluminum welding projects. Remember, practice and experience will help you master the technique over time.

High Strength Bolt

High Strength Bolt,High Strength Hex Bolts,High Strength Anchor Bolts,Round Head Screw

Suzhou Guangxuan Fasteners Co.,Ltd. , https://www.beinuofastener.com